I’m wondering about lazy created rubber cover for power back connector of T865-X. It doesn’t fit strong enough. So, if you youse only power supply by device holder pins – every time, you mount T865 onto the holder (or remove from) – the cover for the backside connector gets lost accidently!

This is a risk specialy for KTM 890 (>2022), because there is a hole in the wind screen (to reduce buffering on helmet). But this hole is exactly where the T865 power backside conector is. So, if you ride during rain, water splashes exacly onto the uncovered backside connector and may demage electronic.

Please send a spare cover 😉
And design a better fitting.

Kind regards
Rainer

Dear João,

thank you very much for great development and support!

I bought new T865+X and Remotecontrol2, but at day after mounting, a technician dropped my bike and demaged several switches at left handle bar – also from Remotecontrol2.

To check, if the buttons are still working, I use https://jaxeadv.com/barbuttons/keypress-tester/

The Outcome is:

4-way-switch(Joystick): ArrowUp, ArrowDown, ArrowLeft, ArrowRight.

2-way-switch: -nothing in test report- (but it turns system volume louder/quieter)

upper button: Enter

upper button, long press: –nothing in test report- (and looks like, no function)

lower button: -nothing in test report- (and looks like, no function)

lower Button, long press: -nothing in test report– (and looks like, no function)

Please can you confirm, or inform about the commands, the buttons should really send?

Kind regards

Rainer