Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 3 October 2024 at 5:50 pm #13714
    Rainer
    Participant

    I’m wondering about lazy created rubber cover for power back connector of T865-X. It doesn’t fit strong enough. So, if you youse only power supply by device holder pins – every time, you mount T865 onto the holder (or remove from) – the cover for the backside connector gets lost accidently!

    This is a risk specialy for KTM 890 (>2022), because there is a hole in the wind screen (to reduce buffering on helmet). But this hole is exactly where the T865 power backside conector is. So, if you ride during rain, water splashes exacly onto the uncovered backside connector and may demage electronic.

    Please send a spare cover 😉
    And design a better fitting.

    Kind regards
    Rainer

    3 October 2024 at 6:51 pm #13719
    João Pereira
    Keymaster

    Not sure you know but that cap is not doing anything there… the connector is fully waterproof even when exposed.

    DMD2 Project Manager & Lead Developer
    Buy Me a Coffee

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.